Vật tư thay thế phần điện

AC Power Supply
High Voltage ~AC PIM 175-264 VAC 2.3A; 47-63Hz
- Universal Voltage AC :
+ Input Voltage : 110 to 220 Vac nominal, 85 to 264 Vac rms, 120 to 373 Vac pk .The universal AC Power Supply and Power Input. Module are not compatible with the legacy High Voltage AC or Low Voltage AC units.
- High Voltage DC : 88 to 140 Vdc
- Low Voltage DC : 20 to 30 Vdc

  Transient data interface và Transient data interface I/O module                                 ----Power: Consumption : 10.5 Watts
-Data: 
+ Front Pane : USB-B
+ 10Base-T/ 100BaseTX I/O : 10Base-T or 100Base-TX Ethernet, autosensing
+ 100Base-FX I/O : 100Base-FX Fiber-Optic Ethernet
- Outout: Front Panel LEDs
+ OK LED : Indicates when the 3500/22M is operating properly
+ TX/RX LED : Indicates when the 3500/22M is communicating with the other modules in the rack
+ TM LED : Indicates when the 3500 rack is in Trip Multiply mode
+ CONFIG OK LED: Indicates that the 3500 rack has a valid configuration

Keyphasor Module và keyphasor I/O module

- Half-height, two-channel module
- Accepts up to two transducer signals
- 3.2 Watts typical power consumption
- Input signal range:
* 0.8V to -21.0V (Non-isolated I/O modules)
 * +5V to -11V (isolated I/O modules)
- Two buffered Keyphasor outputs
- 504Ω maximum buffered output impedance
* -24 VDC, 40 mA maximum per channel power supply

Tachometer Module và techometer I/O module

- Input signal range : +10.0 V to -24.0 V Signals exceeding this range are limited internally by the module
- Input impedance : 20 k Ω (standard), 40 k Ω (TMR),7.15 k Ω (Internal Barrier)
- Output Impedance : 550 Ω
- Recorder : +4 to +20 mA. Values are proportional to module full-scale range (rpm or rpm/min). Individual recorder values are provided for each channel.
- Voltage Compliance (current output): 0 to +12 Vdc range across load. Load resistance is 0 to 600 Ω
- Resolution : 0.3662 µA per bit ±0.25% error at room temperature ±0.7% error over temperature range. Update rate approximately 100 ms
- RPM/Min Accuracy : ± 20 rpm/min
- RPM Accuracy : + Less than 100 rpm = ± 0.1 rpm
+100 to 10,000 rpm = ±1 rpm
+ 10,000 to 99,999 rpm = ± 0.01% of true shaft speed

16 Channel Relay Module và 16 CH Relay MDL

Relay contacts rated: Max 5A; Max 250VAC
Timer relay rated: Max 2A; Max 220VAC
- Standard Relays : Min Switched Current : 100 mA  - 5 Vdc
- DC Specifications (Resistive Load) : Max Switched Current : 3.0 A - 5 to 30 Vdc, 0.3 A -  48 Vdc, 0.11 A  - 125 Vdc.
- AC Specifications (Resistive Load) :
+ Max Switched Current : 3 A
+ Max Switched Voltage : 250 Vac
- Low Current Relays : DC Specifications (Resistive Load)
+ Min Switched Current : 1 mA @ 1 Vdc
+ Max Switched Current :  100 mA - 48 Vdc, 5 mA - 125 Vdc.
- Relay Contact Life : 10,000 cycles

Overspeed Detection Module và overspeed Detection I/O Module

- Input Impedance: 20 k Ω.
- Transducers: Bently Nevada 3300 8 mm Proximitor 3300 16 mm HTPS, 7200 5 mm, 8 mm, 11 mm, and 14 mm Proximitor; 3300 RAM Proximitor, or Magnetic pickups
- Output Impedance: 550 Ω
- Transducer Power Supply: -24 Vdc, 40 mA maximum.
- Recorder: +4 to +20 mA. Values are proportional to module full-scale range (rpm). Module operation is unaffected by short circuits on recorder output.
- Resolution: 0.3662 µA per bit ±0.25% error at room temperature ±0.7% error over temperature range. Update rate approximately 100 ms.
- Relays Type: Single-pole, double-throw (SPDT) relays.
- Max switched power: DC: 120 W AC: 600 VA.
- Max switched current: 5A
- Contact Life: 100,000 @-5 A, 24 Vdc or 120 Vac.

Position Monitor và position I/O Module

- Input Impedance : 1 MΩ (DC LVDT inputs) 10 kΩ (Proximitor* or RPT inputs) 137 kΩ (AC LVDT inputs) 200 kΩ (Rotary Potentiometer inputs)
- Sensitivity :
+ Thrust : 3.94 mV/μm (100 mV/mil) or 7.87 mV/μm (200 mV/mil)
+ Differential Expansion : 0.394 mV/μm (10 mV/mil) or 0.787 mV/μm (20 mV/mil)
+ Ramp Differential Expansion : 0.394 V/mm (10 mV/mil), 0.787 V/mm (20 mV/mil), 3.937 V/mm (100 mV/mil) or 7.874 V/mm (200 mV/mil)
+ Rotary Potentiometer Valve Position : 41 mV/degree rotation
+ Rotary Position Transducer (RPT) Valve Position : 140 mV/deg rotation, 70 mV/deg rotation or 50 mV/deg rotation.
- Transducer Power Supply: 
+ Proximitor or RPT : -24 Vdc
+ DC LVDT : +15 Vdc
+ AC LVDT : 2.3Vrms 3400Hz sine wave
+ Rotary Potentiometer : -12.38 Vdc
+ Recorder : +4 to +20 mA Values are proportional to monitor full-scale
+ Voltage Compliance (current output) : 0 to +12 Vdc range across load Load resistance is 0 to 600 Ω.

Bộ đánh lửa

Heat ignition exciter
Stored energy 20 J
In put voltage 230 VAC
Output voltage 2500 VDC
Working Cycle ( ON/OFF ) 5/1 min
Product No. 1309022 

Bộ khuếch đại tín hiệu 

'- Bộ chia tín hiệu Analog có cách ly, chia 1 tín hiệu ngõ vào thành 2 tín hiệu ngõ ra
-Nguồn cấp: 24VDC
- Ngưỡng điện áp: 16.8… 31.2 V DC
- Input signal: 0 … 20mA, 0… 10V, 0…5V,
                    4…20mA, 2…10V, 1…5V 
                    ( một ngõ vào tùy chọn)
-Output signal: 0 … 20mA, 0… 10V, 0…5V,
                    4…20mA, 2…10V, 1…5V
                    ( hai ngõ ra tùy chọn)
- Sai số: < 0.1%

Relay bảo vệ động cơ

Start type : Direct start up 
Rated current : 25A
DI: DC24V
D0: AC220V/AC380V